VALENTINES HEART SWEATER DIY
Share your love with this Valentines Heart Sweater DIY, using safety pins for the heart will keep it from being too sweet.
Supplies to make your Valentines Heart Sweater DIY:
- 1 Sweater
- Lots of safety pins
- Embroidery thread
- Tape measure
Layout your sweater on a flat surface.
TIP: Take a sheet of paper and slide it inside your sweater. This will make pinning your safety pins much easier and faster.
Using your tape measure, measure down from the center front of your neckline.
I measured 3 inches down. This will be the highest point on your design.
Take your safety pins and pin out from your center point to mark the top of each side of your heart.
With the tops of each side of your heart pinned you can take more safety pins and lay them out in the shape of a heart to decide how big and what shape to make your heart.
When you have the size and shape of your heart laid out, use the rest of your safety pins to fill in your heart.
Once your heart is filled in with safety pins, you are ready to do some embroidery.
My sweater had 2 small holes in it on the side and that’s where I decided to put my embroidery. It just sort of worked out.
Use your pencil to lightly draw the lines for where you want to make your letters.
I marked an X and O.
Take your embroidery thread and your needle, be sure to tie a knot in the end of your thread and start sewing your letters.
TIP: To keep your embroidery thread from pulling loose, on your first stitch before you pull your thread tight, on the back of your sweater run your needle through your thread just above the knot. This loops your thread so it won’t pull out.
I sewed two lines for my letters of simple stitches. You can get as fancy as you want with your stitches. I wanted mine to have a simple look to it.
By mixing up your colors and using safety pins for the heart, this Valentine Heart Sweater DIY doesn’t have to scream Valentine’s Day and you can wear it all year round (weather permitting).
I used an old favorite sweater that had developed some small holes, so this DIY kind of came out of necessity, I couldn’t bear to get rid of it.